SlideRenu SlideSoap Water Slide Cleaner, Gallon SR11128

SlideSoap™ is a uniquely formulated low-foaming technology that encapsulates dirt to remove a variety of surface contaminants from water slides. It may also be used to clean splash pad surfaces, pool decks, soft foam play features and plastic slides. The constant release of micro-action foaming bubbles loosens dirt, body-grime, bird droppings and other residue which can be rinsed easily away without removing slide waxes or other surface protectants. SlideSoap™ contains no volatile organic compounds (VOC’s), petroleum solvents, bleach or ammonia and is biodegradable. The negligible amount of SlideSoap™ used on your water slide WILL NOT CHANGE THE WATER CHEMISTRY OF THE POOL WATER.

RECOMMENDED USES: SlideSoap™ is recommended to be used as a routine maintenance water slide cleaner to emulsify dirt, body-grime, bird droppings, sun tan lotions and other surface contaminants so they can be easily rinsed away with a garden hose or pressure washer. Used regularly, it helps prevent excessive buildup of most surface contaminants. This highly- concentrated low-foaming bubble technology can be used throughout the operating season and won’t strip wax or remove any type of water slide protectant.

DIRECTIONS FOR USE: Shake well before using. Product must be diluted with water. Maximum dilution 12 oz. product to 1 gallon of water. “SlideSoap™ DOES NOT REMOVE HARD WATER MINERAL DEPOSITS OR CALCIUM BUILD-UP”. Use SlideRenu® Calcitrol® to remove calcium carbonate or calcium silicate surface deposits (Refer to Product Data Sheet for Application Instructions). For SlideSoap™ to be the most effective, it must be agitated on the surface with a brush in order to release a constant amount of dirt suspending low-foaming bubbles. Always wash water slides when the surface is cool and not in direct sunlight. The low-foaming bubbles should remain on the surface for 1-2 minutes. Do not allow the soapy water to dry. For superior results, add SlideSoap™ to a pressure washer system at 1 gallon per 1,000 sq. ft. of surface to be treated (dilution ratio of 1:250 is typical) and apply using a soap nozzle, foam gun or water cannon. Rinse off with tap water (hot recommended) through a pressure washer until the foaming action stops. A final rinse with free-flowing water (nozzle off a hose) is recommended to allow the water to sheet off the slide.